|
Click To Enlarge
|
|
These 3xAA box mods incorporate a variable voltage circuit board.
They are adjustable in voltage from 0 to approximately 7 volts. Uses a NCP 630 regulator which minimizes voltage drop when an atty is screwed on.
Sealed 510 connector and sealed tactile switch will help prevent failures.
Placement of the potentiometer allows easy adjustment with a screwdriver or finger nail.
Requires two 14500 batteries(sold seperately)
Due to these being custom made, there may be slight variations or small spaces where the potentiometer exits the box.
Low resistance atomizers are not reccomended for use with higher than 3.7Volts.
The Batteries needed for these box mods are here
http://www.vaporgalaxy.com/UltraFire-LC14500-Protected-37-Volt-900mAh-Li-ON-Battery-LC14500.htm
IMR High Drain Batteries will not work in these boxes because of the flat top nature of the IMR High Drain batteries. Will work with small magnetic battery spacres if you want to use the IMR High Drains.
Measures : 3 and 1/4 inch tall, .6 inchs deep (at its thickest point at the button) and 2 inches wide.
